Nollie 32 Installation Guide

Package Content

  1. Molex to XT30 cable x1
  2. USB 2.0 Internal Motherboard connector to USB PH2.0 cable (50cm) x1
  3. Nollie 32CH Controller x1
  4. 5v 3pin Female to Male adapter x16
  5. 3M Double sided adhesive tape x2

Installation

The controller only needs to be connected to the motherboard USB 2.0 9-pin interface and power supply of the motherboard.

  1. Connect the controller’s USB data cable (2) to the motherboard USB 2.0 9-pin interface.
  2. Connect the controller’s Molex power cable (1). Please note that both Molex power cable must be connected.
  3. Take one of your component, LED strip or Fan or whatever, connect to the controller. This step is to test whether it works properly.
  4. Turn on the computer, at this time, your component will immediately light up with green breathing effect, then you have successfully installed it.
  5. Turn off the computer, install all other components.
  6. For Lian Li Strimer Dual 8 pin/12VHPWR, insert your Lian Li GPU Strimer connector like this:
  7. The Lian Li Strimer requires additional steps, click here for OpenRGB, click here for SignalRGB, click here for NollieRGB.
  8. If it does not light up, please do not continue to operate and contact support immediately.

Precautions

  1. Do not plug the 9-pin USB cable into other interfaces.
  2. Do not mix cables for fully modular PSU. (For example: Asus PSU with Corsair power cable)
  3. Do not plug the motherboard 5v 3-pin into the controller.
  4. Do not plug the motherboard 4-pin RGB into the controller.
  5. When installing ARGB components, be sure to turn off the power and unplug the power cord.

Post Your Comment

Light up your world and create endless possibilities!