Package Content
- Molex to XT30 cable x1
- USB 2.0 Internal Motherboard connector to USB PH2.0 cable (50cm) x1
- Nollie 16CH Controller x1
- 5v 3pin Female to Male adapter x16
- 3M Double sided adhesive tape x2
Installation
The controller only needs to be connected to the motherboard USB 2.0 9-pin interface and power supply of the motherboard.
- Connect the controller’s USB data cable (2) to the motherboard USB 2.0 9-pin interface.
- Connect the controller’s Molex power cable (1). Please note that both Molex power cable must be connected.
- Take one of your component, LED strip or Fan or whatever, connect to the controller. This step is to test whether it works properly.
- Turn on the computer, at this time, your component will immediately light up with green breathing effect, then you have successfully installed it.
- Turn off the computer, install all other components.
- If it does not light up, please do not continue to operate and contact support immediately.
Precautions
- Do not plug the 9-pin USB cable into other interfaces.
- Do not mix cables for fully modular PSU. (For example: Asus PSU with Corsair power cable)
- Do not plug the motherboard 5v 3-pin into the controller.
- Do not plug the motherboard 4-pin RGB into the controller.
- When installing ARGB components, be sure to turn off the power and unplug the power cord.
mine had no sticky pad instead only a ruler thing and this weird box with three rectangular bumps
July 29, 2025please tell me wat is wrong.
nuonuo
April 8, 2026the three rectangular bumps are your sticky pads
wrep
February 17, 2026i also had sticky pads and a small container three rectangular electrial thingimajings (transistors? fuses) it says nothing about it, and i find it strange that they don’t take the time to update the content of the package, at least write wtf it is they are including
nuonuo
April 8, 2026those only included when you purchase from Shopify (nolliergb.cn) or Aliexpress nolliergb.com/aliexpress, not on other sites/platforms/distributors